User's Manual

User Guide

When DHCP is enabled on the Access Point, the new IP address will be needed

in order to access the XenSmart™ web management interface. The Router web

interface can be used to look up the IP address assigned to the Access Point. To

Enable DHCP, click on the drop down menu and select Enable. Select Apply and

then Reboot for the change to take effect.

NOTE: DHCP is set as Disabled by default and is the recommended

setting in order to ensure optimal communications with all Luxul

Xen devices on the network.

IP Address: An IP address is a numerical label assigned to each device on the

network. This ﬁeld shows the IP address that is assigned to the XAP-1010. To

ensure plug and play capability with other Luxul networking products, the IP

Address is automatically defaulted to 192.168.0.10. If desired, the user can set

this to a different static IP Address. To change the IP address of the Access

Point, simply type in the desired IP address (the text ﬁeld will be red if the

address is incomplete), click Apply and then Reboot for the changed to take

effect. When connecting to the Access Point through the XenSmart™ web

interface, the NEW IP Address must be used.

NOTE: Each device on the same network must have a unique IP address.

If the Access Point is assigned an IP address already in use, it

will result in an IP address conﬂict that will need to be resolved

manually. For optimal communications with all Luxul Xen devices

on the network, it is recommended that IP addresses not be

changed unless absolutely necessary.

Subnet Mask: To ensure plug and play capability with other Luxul networking

products, the Subnet Mask is automatically defaulted to 255.255.255.0. If desired,

the user can set this to a different static Subnet Mask.

Default Gateway: A gateway is a router on the network that connects two or

more networks together. Typically the gateway (router) connects the local area

network (LAN) to the Internet. The Internet Service Provider (ISP) often provides

a physical device (usually a DSL modem or cable modem) that connects to the

gateway with an Ethernet cable, thus completing the link to the Internet. For

optimal connectivity and network functionality, this device could also be the

Luxul Xen XBR-2300 Router.

The Default Gateway ﬁeld is the IP address for this routing device. The default

conﬁguration is left blank or empty, allowing the Access Point to automatically ﬁnd

the necessary route to the Internet. It is recommended to leave this ﬁeld blank.