User's Manual

User Guide

NOTE: Regardless of how the XAP-1030 is mounted, be sure to orient

the antenna vertically as demonstrated in the diagrams above.

4.4.4 Connecting the Ethernet Cable

With the XAP-1030 properly mounted and the Antenna installed, you can now plug

the Ethernet Cable into the RJ-45 connector.

NOTE: Category-5, super Category-5 or Category-6 unshielded twisted

pair (CAT5/CAT5e/CAT6 UTP) cables can be used. For best

results, it is recommended that Category-6 shielded twisted pair

be used to ensure stable data transmission at highest data rates.

4.4.5 Connecting to the Power Source

The XAP-1030 is POE ready and supports Legacy (48v 1a), 802.3af, and 802.3at

POE injectors. A POE injector is included with the device. To apply power, simply

connect the opposite end of the Ethernet cable to which the access point is

already connected to the provided POE injector or other POE switch or injector. An

Ethernet cable length of up to 300 feet can be used. DO NOT yet apply power to

the POE injector or switch.

NOTE: To ensure FCC compliance and minimize high frequency noise, a

Ferrite Noise Suppresser is included with the POE injector kit. It

should be placed on the Ethernet cable at or near the connector

on the end of the Ethernet cable that plugs into the POE device.

To install it, simply unsnap the plastic fasteners, place it on the

Ethernet cable as demonstrated below and re-snap the plastic

fasteners to secure it in place.

4.4.6 Connecting to the Internet Source

This Luxul device is not a router and in most installations will be connected to a

Router or Switch in order to deliver Internet access. To do so, connect the POE

injector (or switch) to the desired Internet source using another Ethernet cable. Be

sure the source device is powered off.