User's Manual

User Guide
14
© Copyright 2011 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
Data
Source
Power
Source
Data
In
Power
In
Data/Pwr
Out
POE
Injector
Ferrite Noise
Suppresser
The POE Injector Sends Power and Signal Over One Ethernet Cable
4.4.7 Applying Power
Once the Ethernet cables have been properly connected, connect the power sup-
ply to the POE injector and plug it in to a standard AC power outlet. Or, if plugging
into a POE switch, turn the switch (or appropriate port) on. The network source
device can also now be powered back on.
NOTE: If your Internet source (Router or Switch) is a POE enabled device
and connected via POE, it can be plugged directly into the access
point without the need to run a separate POE injector.
4.4.8 LED Visual Verification
With power applied, you can now verify that the XAP-1030 is connected and
functioning properly. Prior to placing the access point cover plate, perform a visual
inspection of the LEDs. The Green PWR LED (on the left) should be on while the
amber LAN light flashes, indicating activity. Once the XAP-1030 is properly con-
nected to the Internet source, the blue WLAN LED should also remain on. The
Green BRG LED at the right will only be on if the access point is set to function in
bridge mode.