User's Manual

User Guide

5.2 Quick Setup

Quick Setup: For most installations, it is expected that the Quick Setup page will

be sufﬁcient to optimally conﬁgure and deploy the XAP-1030 Wi-Fi network. The

Quick Setup page consists of the following:

DHCP Client: Enabled or Disabled. DHCP (Dynamic Host Conﬁguration Protocol)

is used to automatically assign an IP Addresses to a device on the network. If

DHCP is enabled on the Access Point, it will no longer use the static address set

by Luxul at time of manufacturing and will request a dynamic IP Address from the

Router (sometimes referred to as the Gateway).

When DHCP is enabled on the Access Point, the new IP address will be needed

in order to access the XenSmart™ web management interface. The Router web

interface can be used to look up the IP address assigned to the Access Point. To

Enable DHCP, click on the drop down menu and select Enable. Select Apply and

then Reboot for the change to take effect.

NOTE: DHCP is set as Disabled by default and is the recommended

setting in order to ensure optimal communications with all Luxul

Xen devices on the network.