User's Manual

User Guide
20
© Copyright 2011 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
X
Channel: This field allows the user to set which 2.4GHz channel to use. The
default is set to Channel 6 and is the recommended setting due to the Access
Point being optimized to run on Channel 6. However, any other channel (1-11) may
be selected. To change the Channel, click the dropdown menu, select the desired
channel, then click Save and then Reboot for the change to take effect.
X
Wireless Mode: Sets the type of 802.11 wireless network to be broadcast.
Available modes are:
w
11g (802.11g)
w
11gnHT20 (802.11g/n with 20MHz only channels)
w
11gnHT40+ (802.11g/n with 20/40MHz channels expanding to channels above
the set channel)
w
11gnHT40- (802.11g/n with 20/40MHz channels expanding to channels below
the set channel)
The default setting is 11gnHT20, and is recommended for optimal performance of
all types of devices in the network. Use the 11g Mode ONLY if there are 802.11b/g
client devices in the network that will not connect in 11gnHT20 Mode. 11gnHT40+
and 11gnHT40- Modes should only be used when all client devices in the network
are 802.11n and capable of supporting 40MHz channels.
X
Channel Width: Sets the width of the 802.11n channel. Available widths are:
w
20MHz (only available for 11g and 11gnHT20 modes)
w
40MHZ (only available for 11gnHT40+ and 11gnHT40-)
w
20/40MHz Auto (available for all modes)
The default (and recommended) setting is 20/40 MHz Auto to provide maximum
performance to all client devices and to avoid any potential client issues.
NOTE: HT40 mode will use two channels. For example, if HT40- is
selected and the radio is using channel 6, it would also use
channel 1. If HT40+ is selected and the radio is using channel 6, it
would also use channel 11.
If making any change to the Wireless Settings, select Save and then Reboot for the
settings to take effect.