User's Manual
LU
ll
UL
Simply
Connected
Warning:
Exposure
to
Radio
Frequency
(RF)
Radiation:
The radiated
output
of
this device
is
below
the
FCC
radio frequency exposure limits. Nevertheless,
the
device should be used
in
such a manner
that
the
potential
for
human
contact
during normal
operation
is
minimized.
~
The end user must avoid any extended human
RF
exposure directly in
front
of
the
device, up
to
a distance
of
20cm, when
unit
is
on.
~
When servicing
the
equipment and selecting a location
for
the
antennas,
it
is
important
to
note
that
a minimum distance
of
20cm
is
required between personnel and
the
device
or
antenna
to
comply
with
the
radio frequency exposure limit.
~
The antenna used
for
this transmitter must be installed
to
provide a separation distance
of
at
least 20cm
from
all persons and must
not
be co-located
or
operating
in
conjunction
with
any
other
antenna
or
transmitter.
The
following safety precautions should be observed:
~
Do
not
touch
or
move
the
antenna
while
the
unit
is
transmitting
or
receiving.
~
Do
not
hold
any
component
containing
the
radio such
that
the
antenna
is
very close
or
touching
any exposed parts
of
the
body, especially
the
face
or
eyes,
while transmitting.
~
Do
not
operate
the
radio
or
attempt
to
transmit data unless
the
antenna
is
connected; this
behavior may cause damage
to
the
radio.
FCC
Statement-Wireless
FCC
2.4GHz 802.llbgn
This device complies
with
Part
15
of
the
FCC
Rules.
Operation
is
subject
to
the
following
two
conditions:
(1)
This device may
not
cause harmful interference, and
(2)
this device must accept any
interference received, including interference
that
may cause undesired operation.
This equipment
has
been tested and found
to
comply
with
the
limits
for
a
Class
B digital device,
pursuant
to
Part
15
of
the
FCC
Rules.
These limits are designed
to
provide reasonable
protection
against harmful interference in a residential installation. This equipment generates,
uses
and can
radiate radio frequency energy and,
if
not
installed and used in accordance
with
the
instructions,
may cause harmful interference
to
radio communications. However, there
is
no
guarantee
that
interference
will
not
occur in a particular installation.
If
this equipment does cause harmful interfer-
ence
to
radio
or
television reception, which can be determined by turning
the
equipment
off
and
on,
the
user
is
encouraged
to
try
to
correct
the
interference by one
of
the
following
measures:
~
Reorient
or
relocate
the
receiving antenna.
~
Increase
the
separation between
the
equipment and receiver.
~
Connect
the
equipment
into
an
outlet
on a circuit
different
from
that
to
which
the
receiver
is
connected.
~
Consult
the
dealer
or
an
experienced
radio/TV
technician
for
help.
FCC
Caution:
Any changes
or
modifications
not
expressly approved by
the
party responsible
for
compliance could void
the
user's
authority
to
operate this equipment.
This transmitter must
not
be co-located
or
operating
in
conjunction
with
any
other
antenna
or
transmitter.
©
2014
Luxul.
All
Rights
Reserved.
Other
trademarks
and
registered
trademarks
are
the
property
of
their
respective
owners