Simply Connected Quick Install Guide XFS-1816P 18-Port/16 PoE+/2 Gig Uplink Smart Switch Use the XFS-1816P to: f Connect up to 16 IP Cameras or Other PoE-Enabled Devices f Add PoE/PoE+ Capability to Your Network (Max Output 230 Watts) f Enable High Speed LAN Connectivity with Gigabit Uplinks f Simply Plug and Play
XFS-1816P Quick Install Guide Quick Install Guide Model Number: XFS-1816P 18-Port/16 PoE+/2 Gig Uplink Smart Switch © 2015 Luxul. All Rights Reserved. No part of this publication may be modified or adapted in any way, for any purposes without permission in writing from Luxul. The material in this manual is subject to change without notice. Luxul reserves the right to make changes to any product to improve reliability, function, or design.
Simply Connected PACKAGE CONTENTS f 18-Port/16 PoE+/2 Gig Uplink Smart Switch f Power cable f Two L-shape brackets and eight matched screws f Four rubber footpads f Quick Install Guide If any of the listed items are missing or damaged, please contact the reseller from whom you purchased for return/replacement. HARDWARE DESCRIPTION Front Panel The front panel of the XFS-1816P switch includes 16 10/100Mbps ports, 2 Gigabit uplink ports and 1 shared Gigabit SFP port.
XFS-1816P Quick Install Guide Indicator Name Description Power On Indicates that there is power to the XFS-1816P Off If LED is off, check power connections and on/off switch at the back of the unit. On There is a device connected to the port. Flashing A port is receiving or transmitting data. Off There is nothing connected to the port.
Simply Connected Network Ports ff 16 10/100Mbps RJ-45 ports (Ports 1~16), that support Auto MDI/MDIX. ff 2 Gigabit uplink ports ff 1 shared Gigabit SFP port. NOTE: The SFP expansion port cannot support optical connections until equipped with an SFP (Mini GBIC) optical module. NOTE: When powering up, the port LEDs corresponding to the optical interface may take a moment to initialize.
XFS-1816P Quick Install Guide 3.2 Before Connecting to the Network f The XFS-1816P can be rack-mounted or used as a desktop switch. Before connecting to the network, please be aware of the following requirements: f Install the XFS-1816P in a stable/safe place to avoid any possible damage f Make sure there is adequate space around the XFS-1816P for adequate ventilation and proper heat dissipation. It is recommended to have at least 4-6 inches around all sides.
Simply Connected Network Connections The XFS-1816P supports 10/100 Mbps half/full-duplex mode. All RJ-45 ports support Auto MDI/MDIX and can be used as ordinary ports or as Uplink ports. Any RJ-45 port can be used to connect the XFS-1816P to an Ethernet enabled device (including servers, routers, and other switches) without a crossover cable. The XFS-1816P offers 2 Gigabit uplink ports and 1 shared Gigabit SFP module expansion port.
4. Check to see that the IP address of the computer is within this network segment: 192.168.0.xxx (“xxx” ranges 2~254. For example, 192.168.0.50). For IP address settings, refer to Appendix 2. 5. Open the Web browser and enter 192.168.0.3. The switch login window appears. 6. Enter the user name and password (default user name and default password are both set as “admin”), and then click “OK” to login to the switch configuration window.
