Simply Connected Quick Install Guide XMS-1024 24-port Gigabit Managed Switch Use the XMS-1024 to: f Expand Your Home or Office Network f Provide Intuitive Network Management f Future Proof Your Network with Gigabit Speeds (10X Performance of Fast Ethernet) f Optimize and Protect Your Network with Advanced VLAN, QoS and Network Security Features
XMS-1024 Quick Install Guide Quick Install Guide Model Number: XMS-1024 24-port Gigabit Managed Switch © 2014 Luxul. All Rights Reserved. No part of this publication may be modified or adapted in any way, for any purposes without permission in writing from Luxul. The material in this manual is subject to change without notice. Luxul reserves the right to make changes to any product to improve reliability, function, or design.
Simply Connected PACKAGE CONTENTS The following items should be included in the box: f XMS-1024 Gigabit Managed Switch f Power Cord f Two L-shaped rack mounting brackets and screws f Four rubber pads f One RJ-45 to Serial Console Cable f Quick Installation Guide If any of the listed items are missing or damaged, please contact the Distributor from whom you purchased for return/replacement.
XMS-1024 Quick Install Guide The green LED indicators show the working status of the switch. The following table describes the LED functionality: Indicator Name LED Description Power On This LED indicates that there is power to the XMS-1024 Off If LED is off, check power connections.. On The Link/Activity LED of the port will be on if there is a device connected to the port. Flashing The Link/Activity LED flashes when a port is receiving or transmitting data.
Simply Connected PREPARING FOR INSTALLATION System Requirements ff Ethernet Cables to connect the XMS-1024 to Ethernet enabled devices ff Computer equipped with a Web browser. Supported Web browser versions include I.E. 9.0, Firefox 3.6, Safari 5.0, Chrome 6.0, Opera 10.6 and up. The Web browser is used to configure the XMS-1024. ff Power must be AC 100-240V~ 0.6A(Max) 50/60Hz. Before Connecting to the Network The XMS-1024 can be rack-mounted or used as a desktop switch.
XMS-1024 Quick Install Guide Rack-Mounting the XMS-1024 f Using the included screws, attach the mounting ears to each side of the switch. f Mount the switch in the rack with the LEDs facing outwards. Be sure the switch is level and properly secured within the rack. Desktop Setup For use as a desktop device, position and apply the included rubber feet to the bottom of the XMS-1024.
Simply Connected Optical fiber/cable should be selected based on the wavelength of the SFP optical module to be used. Make sure only one Uplink channel exists between switches or between the XMS1024 and a router. Otherwise, loops can occur and result in network failure. Default IP Address The XMS-1024 default IP address is 192.168.0.2. This address can be changed. However, for hassle free installation of other plug and play Luxul devices, it is recommended that the default IP value be maintained.
WARNINGS AND SAFETY INFORMATION ff Verify that the electrical circuits have appropriate grounding and overload protection. ff Attach only approved power cords to the device. ff Verify there is adequate ventilation around the device, and that ambient temperatures meet equipment operation specifications. ff The XMS-1024 is designed for indoor use only. DO NOT place this outdoors. ff DO NOT install in or near hot or humid places, such as a kitchen or bathroom.