Manual

243
User Guide
© 2014 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
Extended Power-via-MDI TLV, Hardware Revision TLV and so on.
NOTE: For detailed introduction of TLV, please refer to IEEE 802.1AB
standard and ANSI/TIA-1057.
In the Switch, the following LLDP optional TLVs are supported:
Port Description TLV The Port Description TLV allows Network Management to
advertise the IEEE 802 LAN station's Port Description.
System Capabilities TLV The System Capabilities TLV identies the primary functions
of the System and whether or not these primary functions
are enabled.
System Description TLV The System Description TLV allows Network Management
to advertise the System's Description, which should include the
Name and Version identication of the system's hardware type,
software operating system, and Networking software.
System Name TLV The System Name TLV allows Network Management to
advertise the system's assigned Name, which should be the
system's fully qualied Domain Name.
Management Address TLV The Management Address TLV identies an Address associated
with the local LLDP Agent that may be used to reach higher
entities to assist in discovery by Network Management.
Port VLAN ID TLV The Port VLAN ID TLV allows a VLAN Port to advertise the
Port's VLAN Identier (PVID) that will i s associated with
Untagged or Tagged frames.
Port And Protocol VLAN
ID TLV
The Port And Protocol VLAN ID TLV allows a Port to
advertise a Port and protocol VLAN ID.
VLAN Name TLV The VLAN Name TLV allows an IEEE 802.1Q-compatible IEEE
802 LAN station to advertise the assigned Name of any VLAN
with which it is congured.
Link Aggregation TLV The Link Aggregation TLV indicates whether the link is
capable of being aggregated, whether the link is currently
in an aggregation group, and if in an aggregation the Port
identication of the aggregation group.
MAC/PHY
Conguration/Status TLV
The MAC/PHY Conguration/Status TLV identies: a)The
duplex and bit-rate capability of the sending IEEE 802.3 LAN
node that is connected to the physical medium; b)The current
duplex and bit-rate settings of the sending IEEE 802.3
LAN node; c)Whether these settings are the result of auto-
negotiation during link initiation or manually set.
Max Frame Size TLV The Maximum Frame Size TLV indicates the maximum frame
size capability of the implemented MAC and PHY.
Power Via MDI TLV The Power Via MDI TLV allows Network Management to
advertise and discover the MDI power supPort capabilities of the
sending IEEE 802.3 LAN station.
The LLDP module is used for LLDP function configuration of the Switch and includes
three submenus: LLDP Config, Device Info, Device Statistics and LLDP-Media.