Manual
89
User Guide
© 2014 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
The following entries are displayed on this screen:
Global Config
GVRP:
Enable/Disable the GVRP function.
Port Config
Port Select:
Click the Select button to quick-select the corresponding entry.
Select:
Select the desired Port(s) for configuration.
Port:
Displays the Port number.
Status:
Enable/Disable the GVRP feature on the Port. The Port type must be set
to TRUNK before enabling the GVRP feature.
Registration Mode:
Select the Registration Mode for the Port.
Normal: A Port can dynamically register/un-register a VLAN and
propagate the dynamic/static VLAN information.
Fixed: A Port cannot register/un-register a VLAN dynamically. It only
propagates static VLAN information.
Forbidden: A Port cannot register/un-register VLANs. It only
propagates VLAN1 information
LeaveAll Timer:
Once the LeaveAll Timer is set the Port with GVRP enabled can send a
LeaveAll message after the timer expires, so the other GARP entities can
re-register all the attribute information on this entity. After re-registration
the entity restarts the LeaveAll Timer to begin a new cycle. The LeaveAll
Timer ranges from 1000 to 30000 centiseconds (10.00 to 300.00 seconds)
the default value is 1000 centiseconds.
Join Timer:
To guarantee the transmission of the Join Messages the GARP Port sends
each Join Message two times. The Join Timer is used to define the interval
between the two sending operations of each Join Message. The Join
Timer ranges from 20 to 1000 centiseconds (0.20 to 10.00 seconds) the
default value is 20 centiseconds.
Leave Timer:
Once the Leave Timer is set the GARP Port receiving a Leave message will
start its Leave Timer and un-register the attribute information if it does
not receive a Join Message again before the Timer expires. The Leave
Timer ranges from 60 to 3000 centiseconds (0.60 to 30.00 seconds) the
default is 60 centiseconds
LAG:
Displays the LAG Group to which the Port belongs.