Quick Install Guide

ManualsBrandsLuxul ManualsElectronicsWireless Controller

Fo ld Fo ld Fo ld

READ ME FIRST

BEFORE YOU BEGIN INSTALLATION

Controller Setup Sequence: Once you conﬁgure the XWC-2000 Wireless

Controller, the controller will automatically conﬁgure and manage all

compatible APs on the same subnet; however, APs can be added or removed

at any time. A DHCP server is required on the network.

Firmware Updates: The XWC-2000 Wireless Controller automatically

checks for ﬁrmware updates of controller-compatible APs and the Wireless

Controller itself but requires internet access to do so. The Wireless

Controller will still operate without internet access, but ﬁrmware updates will

not be available.

Physical Installation

Connecting Devices: The XWC-2000 Wireless Controller simply

connects to the network along with any compatible access points.

Wireless Controller

PoE Injector or

compatible PoE Switch

LAN

Wireless Controller

XWC-2000

Package Contents:



XWC-2000 Wireless Controller



Rack mount kit



Rubber feet



Power cord



LAN cable

QUICK INSTALL GUIDE

Sales

801-822-5450

sales@luxul.com

Technical Support

801-822-5450

support@luxul.com

LUX-QIG-XWC-2000-v4 08151802

No part of this document may be modiﬁed or adapted in any way, for any purposes without permission

in writing from Luxul. The material in this document is subject to change without notice. Luxul reserves

the right to make changes to any product to improve reliability, function, or design. No license is granted,

either expressly or by implication or otherwise under any Luxul intellectual property rights. An implied

license only exists for equipment, circuits and subsystems contained in this or any Luxul product.

Connected are all trademarks and or registered trademarks of Luxul Wireless, Inc. All other trademarks and

registered trademarks are property of their respective holders.

Summary of content (2 pages)

PAGE 1
Fold Technical Support 801-822-5450 support@luxul.com READ ME FIRST Sales 801-822-5450 sales@luxul.com Fold QUICK INSTALL GUIDE Fold BEFORE YOU BEGIN INSTALLATION XX XX Controller Setup Sequence: Once you configure the XWC-2000 Wireless Controller, the controller will automatically configure and manage all compatible APs on the same subnet; however, APs can be added or removed at any time. A DHCP server is required on the network.
PAGE 2
Fold XX Fold Access Point Placement: Place APs to ensure adequate coverage but not so far apart there is no signal overlap. You may have to experiment with AP placement to optimize the roaming experience. The APs should overlap enough that the client device has a good connection to the AP to which it is currently attached but also sees the next-nearest AP. nnNote: Consider using Ekahau HeatMapper to assist with this process, available from www.ekahau.com.