Operation Manual

FlarmView Version 1.01 November 2013
Page 14 of 21
If Target label is active, near glider will be displayed chosen value.
Show A/C range Shows A/C ring on flarm radar screen
Lock on nearest automatically selects nearest target and displays its data
4.9.4 Sounds
In the Sounds setup menu volume settings for the LXNAV FlarmView and alarms settings can
be modified.
• Volume The sounds slider changes the alarm volume.
• Beep on traffic FlarmView will notify with short beep a presence of a new Flarm
object
• Beep on low alarm FlarmView will beep on low level alarms triggered by Flarm
• Beep on important alarm FlarmView will beep on important level alarms triggered
by Flarm
• Beep on urgent alarm FlarmView will beep on critical level alarms (collision)
triggered by Flarm
4.9.5 Units
Use this menu to specify units.
4.9.6 Hardware
On this page we can configure baudrate of serial interface. If we use more than one
FlarmView connected to Flarm, Communication setting must be set to Rx –Slave. That will
allow to Master FlarmVier to communicate with Flarm in both directions.