Operation Manual

LX90xx system Version 4.0 February 2014
Page 110 of 151
 Wind will open a dialogue where wind changes with altitude are shown, wind can be
set and methods for wind calculation are shown. See Chapter 6.5.6.4 for more details.
 Airspace shows a list of airspace zones in the vicinity of the current position. See
Chapter 6.5.6.5 for more details.
 Pan will change main display unit into panning mode. In this mode user can move over
map in all directions.
 Rot.FAI will rotate the FAI area if it is enabled. This option is not shown if it is not
enabled.
 Event is used to log an event. The recording rate will be increased to 1 second for one
minute. A message “Event marked” will be shown on the screen.
 Send is available only with two-seat configurations. Press this button to send the task
to the rear seat device. This action will force a change of task on the rear seat device.
 Layout will run page layout editor. In layout editor, it is possible to modify layout of
current navigational page.
 Night will reduce backlight to level acceptable for flying in very dark conditions.
 Off will switch off the instrument. The Message “LX9000 switching off” will be
displayed.
6.7.1 Task Edit
Press the EDIT button and the task edit dialogue will open. A task is created and
manipulated within this dialogue. A list of task points is shown. In the upper-left corner the
type and total distance is displayed. In the upper-right corner the task time is shown. Use
the PAGE selector knob to select task points or task time control.
There are numerous actions available within the task edit dialogue to make creation of tasks
as easy as possible.
Press the MORE>> button to see more options. Available actions are:
 Press the EDIT button to enter a new task point, edit an existing one or to enter task
time.
 OK action will confirm changes to the task and return to the navigational page.
 CANCEL action will cancel all modifications of the task and return to the navigational
page.
 Use the ZONE button to modify the observation zone for selected point. The default
zone style is defined in the Observation Zones menu in setup mode (see Chapter 6.1.8).
 OPTIONS action will open a new dialogue where additional properties for the task can
be defined. The task name is set in this dialogue.
 There are three different methods of creating task. List mode. Detailed list mode and
map mode. Press VIEW button to change method.