Operation Manual

LX90xx system Version 4.0 February 2014
Page 58 of 151
increase the radius by 0.1 of the selected distance units and the ZOOM selector knob to
increase the radius by 5.
If Line is not checked the Angle1 parameter will define the basic shape of the observation
zone. A value of 180° means that the zone is a cylinder and 45° is the classical FAI sector.
Rotate the PAGE selector knob to increase the angle by 0.5° or use the ZOOM selector knob
to choose values 22.5°, 45°, 90° or 180°.
Angle2 and Radius2 are used for more complex observation zone setups.
When changing observation zone parameters the screen is automatically updated to display
the new zone.
Check the AAT checkbox, if you want to make the selected zone an assigned area. The
AAT checkbox will be automatically checked when Radius1 is greater than 10 km.
By default navigation to task points will be automatically advanced; uncheck Auto next if
you do not want to change over to next point when reaching selected point. This option will
be automatically unchecked when Radius1 is greater than 10 km.
Use Template if you wish to modify start, point and finish zones at same time.
Available templates are:
 500 m cylinders are used for start, points and finish.
 FAI sectors, 90° and 3 km long sector is use in start, turn point and finish.
 500m and start line. The 500 m cylinder is used for turn points. A 1 km long line is
used for start and finish.
 FAI and start line. 90° and 3 km long sector is used for turn points. A 1 km long line is
used for start and finish.