Operation Manual

LX90xx system Version 4.0 February 2014
Page 74 of 151
NMEA data is available also on Flarm display port on main display unit and rear
display unit at 19200bps. However only Flarm data and GPS data.
6.1.12.12 Engine *
Use this menu, when the system is installed into glider with engine. The current engine
noise level is shown as a progress bar. If external MOP sensor is installed also MOP level
will be shown.
Set Threshold to define when engine is running. By default threshold is set to 100%, which
means no engine run will be detected. Lower this value to approximately 80% to detect
engine running. Engine total time will be accumulated and displayed in total time box. If
necessary, total time can be adjusted, to match current engine total time.
6.1.12.13 Flaps*
When flap sensor is installed, use this menu to set flaps position. Use page selector to select
desired flap position. Press SET button to set position. Continue with procedure for all flap
positions.
When all flap positions are set, a green dot will be displayed with current flap position.
If flap labels are not set yet, press EDIT button to name flap label. Flap labels must me
entered with increasing speed range. It is recommended that flaps labels are set together
with speed range in Polar and Glider setup. See Chapter 6.1.13 for more details.