user manual

Step 4 – Assemble Optional Keyboard Brackets
1. Fasten the keyboard to the keyboard mounting plate. Use four 8-32x5/8 screws to attach the
95-key keyboard. Use four 10-32x5/8 screws to attach the 60-key keyboard.
Note Excess keyboard cable length can be looped around the hooks on the bottom
of the keyboard mounting plate.
2. Attach the keyboard mounting plate to the side mount brackets using the two adjusting
knobs.
3. Adjust the angle of the keyboard by loosening the two adjusting knobs, adjusting the
keyboard angle and then tightening the adjusting knobs,
Step 5 – Complete Assembly
1. If using a UPS battery pack, the battery pack can be mounted to the bottom mounting
bracket. Place a locking washer and then a flat washer on a 1/4-20x2 bolt. Thread the bolt
through the UPS Battery Pack, then through the 1” aluminum spacer and into the mounting
bracket.
2. Connect all cables to the VX7. Secure the cables with the strain relief cable clamps, ensuring a
slack loop remains between the cable clamp and the accessory connector.
3. The vehicle mounted bracket and the VX7 are now ready to use.