User's Manual

196 Cisco Client Configuration
MX3X Reference Guide E-EQ-MX3XRG-H
Cisco WPA Configuration
Use the following instructions for all authentication protocols to configure the Microsoft Wireless
Network configuration utility unless WPA/LEAP is used.
WPA/LEAP is configured with the Cisco ACU (see Section titled “WPA/LEAP Authentication
Configuration”).
Tap the ACU icon on the desktop.
Figure 5-27 Cisco ACU Profile Selection
From the Select Active Profile pull down list, select <External Settings>.
Tap OK and warmboot.
Figure 5-28 Cisco ACU Reboot Message
After booting up, the Microsoft Zero Config tool should start. If it does not, start configuring the
wireless connection by tapping the icon on the task bar shown in below.
Figure 5-29 Microsoft Wireless Connection Icon