User's Manual
Table Of Contents
- 95 Series RFID System User’s Guide
- Table of Contents
- List of Figures
- Preface
- Introduction
- Reader R95 Installation and Connections
- Exciter E95 Installation and Connections
- Power Supply TRM95 Installation and Connection
- Configuration and Operation
- Before You Begin
- General Procedure Rules
- Setting Up the Reader/PC Connection
- Reader’s Power-up Sequence
- Learning Procedure (Optional)
- Resetting the Reader
- Checking the Reader’s Basic Parameters
- Setting Up the Exciter’s Address
- LF Transmitter Output
- Configuring the Reader
- Setting Up the Carrier Threshold
- Setting Up the Exciter’s Test-Tag
- Setting Up the Real Time Clock
- Configuring the Reader’s Application Parameters
- Configuring the Reader’s Network Parameters
- Storing the Reader’s Configuration
- Reader - Final Setup
- 95 Series RFID System - Final Test
- Programming and Testing the Transponder T95
- Troubleshooting
- Specifications
- Transponder T95 Messages
- Excitation Modes
- Reader Software Upgrade Procedure
- Glossary
- Index
What This Manual Contains
Preface i
Preface
What This Manual Contains
This manual gives procedures for installing and configuring the Reader R95 and the
Exciter E95, and programming the Transponder T59. It also gives you maintenance
and troubleshooting procedures.
Summary A summary of the contents of this manual is given below:
Chapter 1, Introduction, describes the Transponder Identification System and the
Postal RFID System. It also gives information on the 95 Series RFID System
configuration principles.
Chapter 2, Reader R95 Installation and Connections, explains how to install and
connect the Reader, set the jumpers for the interfaces, and connect external devices to
the Reader, if necessary.
Chapter 3, Exciter E95 Installation and Connections, explains how to assemble the
Exciter using the LF antenna kit and the Enclosure E95 kit, make the LF antenna
connection, connect the serial interfaces and power supply, set the jumpers for the
interfaces, and connect remote devices to the Reader.
Chapter 4, Power Supply TRM95 Installation and Connection, explains how to install
the unit and make input and output connections to the unit.
Chapter 5, Configuration and Operation, provides procedures for setting up and
configuring a 95 Series RFID System.
Chapter 6, Programming and Testing the Transponder T95, explains how to set up a
site and gives procedures for programming the Transponder T95.
Chapter 7, Troubleshooting, describes maintenance and troubleshooting procedures
that you must follow when using the 95 Series RFID System.
Appendix A, Specifications, gives electrical, environmental, and physical
specifications for the Transponder T95, the Reader R95, the Exciter E95, and for the
complete 95 RFID System.
Appendix B, Transponder T95 Messages, describes the T95 Message format.
Appendix C, Excitation Modes, describes the various excitation modes (signal
descriptions) and their associated parameter settings.
Appendix D, Reader Software Upgrade Procedure, describes the procedures for
upgrading the Reader R95 (P/N 600405) main software using the serial interface
RS232 or RS485.
The Glossary is an alphabetical listing of terms and acronyms used in this manual.