User's Manual
Table Of Contents
- 95 Series RFID System User’s Guide
- Table of Contents
- List of Figures
- Preface
- Introduction
- Reader R95 Installation and Connections
- Exciter E95 Installation and Connections
- Power Supply TRM95 Installation and Connection
- Configuration and Operation
- Before You Begin
- General Procedure Rules
- Setting Up the Reader/PC Connection
- Reader’s Power-up Sequence
- Learning Procedure (Optional)
- Resetting the Reader
- Checking the Reader’s Basic Parameters
- Setting Up the Exciter’s Address
- LF Transmitter Output
- Configuring the Reader
- Setting Up the Carrier Threshold
- Setting Up the Exciter’s Test-Tag
- Setting Up the Real Time Clock
- Configuring the Reader’s Application Parameters
- Configuring the Reader’s Network Parameters
- Storing the Reader’s Configuration
- Reader - Final Setup
- 95 Series RFID System - Final Test
- Programming and Testing the Transponder T95
- Troubleshooting
- Specifications
- Transponder T95 Messages
- Excitation Modes
- Reader Software Upgrade Procedure
- Glossary
- Index
Transponder Identification System
Introduction 1-1
Chapter 1
Introduction
This chapter describes Transponders and their functions, the purpose of the Postal
RFID System and its uses. It also gives information on the 95 Series RFID System
configuration principles.
Transponder Identification System
The purpose of a data capture or identification system that uses a Transponder as an
identification token is:
• To automatically identify animate or inanimate objects having attached a
Transponder with an unique identifier
• To ensure that information is available in a format that can be readily accepted by
acomputer
• To minimize the possibility of errors in the identification process.
The concept of Radio Frequency Identification (RFID) is presented in Figure 1-1.
Figure 1-1: RFID Concept
Reading Point
Transponder
Rx
Tx
µC
Tx
µC
Rx
Downlink
Uplink
Interface
Interface
Main
PC