User's Manual
Table Of Contents
- 95 Series RFID System User’s Guide
- Table of Contents
- List of Figures
- Preface
- Introduction
- Reader R95 Installation and Connections
- Exciter E95 Installation and Connections
- Power Supply TRM95 Installation and Connection
- Configuration and Operation
- Before You Begin
- General Procedure Rules
- Setting Up the Reader/PC Connection
- Reader’s Power-up Sequence
- Learning Procedure (Optional)
- Resetting the Reader
- Checking the Reader’s Basic Parameters
- Setting Up the Exciter’s Address
- LF Transmitter Output
- Configuring the Reader
- Setting Up the Carrier Threshold
- Setting Up the Exciter’s Test-Tag
- Setting Up the Real Time Clock
- Configuring the Reader’s Application Parameters
- Configuring the Reader’s Network Parameters
- Storing the Reader’s Configuration
- Reader - Final Setup
- 95 Series RFID System - Final Test
- Programming and Testing the Transponder T95
- Troubleshooting
- Specifications
- Transponder T95 Messages
- Excitation Modes
- Reader Software Upgrade Procedure
- Glossary
- Index
Before You Begin
Exciter E95 Installation and Connections 3-1
Chapter 3
Exciter E95 Installation and Connections
This chapter explains how to:
• Assemble the Exciter E95 using LF Antenna Kit (P/N 600420) and Enclosure E95
Kit (P/N 600421)
• Make the LF antenna connections
• Connect serial interfaces and power supply
• Set the jumpers for interfaces
• Connect remote devices to the Reader R95 (optional)
Before You Begin
Before starting the installation:
• Read Chapter 4, Setup Guidelines in the 95 Series RFID System Technical Guide.
• Have at your disposal, the complete approved documentation describing the RFID
System configuration, equipment location, and wiring distances between
equipment (see the Site Survey Documentation).
• Check whether the mechanical supports for the Exciters are installed on the site
according to the approved documentation (see the Site Survey Documentation).
• Set a color table for the serial interfaces and power supply cables. Pay special
attention to the interface terminals, cable shield, and the ground wires.
• Check whether the LF Antenna Kit (P/N 600420) and Enclosure E95 Kit
(P/N 600421) are complete, according to the product shipping list.
Tools To install the Exciter E95, you will need the following tools:
• Screwdriver SR1 (square recess # 1)
• Rubber mallet
• Hexagonal fix key # 10