User's Manual
Table Of Contents
- 95 Series RFID System User’s Guide
- Table of Contents
- List of Figures
- Preface
- Introduction
- Reader R95 Installation and Connections
- Exciter E95 Installation and Connections
- Power Supply TRM95 Installation and Connection
- Configuration and Operation
- Before You Begin
- General Procedure Rules
- Setting Up the Reader/PC Connection
- Reader’s Power-up Sequence
- Learning Procedure (Optional)
- Resetting the Reader
- Checking the Reader’s Basic Parameters
- Setting Up the Exciter’s Address
- LF Transmitter Output
- Configuring the Reader
- Setting Up the Carrier Threshold
- Setting Up the Exciter’s Test-Tag
- Setting Up the Real Time Clock
- Configuring the Reader’s Application Parameters
- Configuring the Reader’s Network Parameters
- Storing the Reader’s Configuration
- Reader - Final Setup
- 95 Series RFID System - Final Test
- Programming and Testing the Transponder T95
- Troubleshooting
- Specifications
- Transponder T95 Messages
- Excitation Modes
- Reader Software Upgrade Procedure
- Glossary
- Index
Before You Begin
Configuration and Operation 5-1
Chapter 5
Configuration and Operation
This chapter explains how to set-up and configure a 95 Series RFID System. The IPC
implementation is a practical example of the 95 Series RFID System configuration.
For more information about the 95 Series RFID System configuration, refer to the
95 Series RFID System Technical Guide.
Before You Begin
Before starting the RFID System configuration, do the following:
1. Check whether all equipment is correctly installed and interconnected according
to the requirements stated in Chapter 2, Reader R95 Installation and Connections
and Chapter 3, Exciter E95 Installation and Connections in this guide.
2. Create a unique address for each Reader and Exciter according to the approved
documentation describing the RFID System configuration (see the specific Site
Survey documentation).
3. Familiarize yourself with the instructions format described in the 95 Series RFID
System Reference Guide, and the system’s functionality described in the 95 Series
RFID System Technical Guide.
4. Refer to the section, 95 Series RFID System Configuration Principles on page 1-3,
for some general explanations on configuring the 95 Series RFID System.
General Procedure Rules
You have to configure each Reader and Exciter in the RFID System.
Lyngsoe recommends that you follow the general rules listed below:
1. Configure each identification zone, onebyone,byusingaPC/Laptopthatis
directly connected to a Reader. By doing this, you can control the Reader, and all
Exciters interconnected to it from this PC.
2. Follow the step-by-step instructions described in this chapter.
3. If you do not obtain the expected results, refer to Chapter 7, Troubleshooting.