User's Manual
Table Of Contents
- 95 Series RFID System User’s Guide
- Table of Contents
- List of Figures
- Preface
- Introduction
- Reader R95 Installation and Connections
- Exciter E95 Installation and Connections
- Power Supply TRM95 Installation and Connection
- Configuration and Operation
- Before You Begin
- General Procedure Rules
- Setting Up the Reader/PC Connection
- Reader’s Power-up Sequence
- Learning Procedure (Optional)
- Resetting the Reader
- Checking the Reader’s Basic Parameters
- Setting Up the Exciter’s Address
- LF Transmitter Output
- Configuring the Reader
- Setting Up the Carrier Threshold
- Setting Up the Exciter’s Test-Tag
- Setting Up the Real Time Clock
- Configuring the Reader’s Application Parameters
- Configuring the Reader’s Network Parameters
- Storing the Reader’s Configuration
- Reader - Final Setup
- 95 Series RFID System - Final Test
- Programming and Testing the Transponder T95
- Troubleshooting
- Specifications
- Transponder T95 Messages
- Excitation Modes
- Reader Software Upgrade Procedure
- Glossary
- Index
Setting Up the Reader/PC Connection
5-2 Configuration and Operation
Setting Up the Reader/PC Connection
To connect the Reader to a PC, do the following:
1. UsetheRS-232orRS-485communicationlinetoconnecttheReadertothePC.
For more information on these communication lines, see Connecting the RS-232
Communication Line,andConnecting the RS-485 Four-Wire Communication Line
in Chapter 2.
For the initial set-up, Lyngsoe recommends using the RS-232 connection with a local,
mobile PC (Laptop), as shown in Figure 5-1 below.
Figure 5-1: Connecting the Reader to a PC/Laptop
2. Run a terminal emulation program on the PC, such as, HyperTerminal in
Windows 95, Terminal in Windows 3.x, or Procomm in DOS or any version of
Windows. The recommended configuration for the PC’s port is:
• Data rate - 19200 bps
•Databits -8bits
• Parity - none
•Stopbits -1
• Flow control - none
M
a
t
h
e
r
b
o
a
r
d
M
B
D
9
5
Controller CTL95
TX
RX
1
RS232
TB8
Red LED
DATA
Green LED
POWER
Reset Button
TX GND RX
COM1/DB9
RS232 Cable
RS232
RS4852
Interface
Selection
J2
P2
Relay