User's Manual
Table Of Contents
- 95 Series RFID System User’s Guide
- Table of Contents
- List of Figures
- Preface
- Introduction
- Reader R95 Installation and Connections
- Exciter E95 Installation and Connections
- Power Supply TRM95 Installation and Connection
- Configuration and Operation
- Before You Begin
- General Procedure Rules
- Setting Up the Reader/PC Connection
- Reader’s Power-up Sequence
- Learning Procedure (Optional)
- Resetting the Reader
- Checking the Reader’s Basic Parameters
- Setting Up the Exciter’s Address
- LF Transmitter Output
- Configuring the Reader
- Setting Up the Carrier Threshold
- Setting Up the Exciter’s Test-Tag
- Setting Up the Real Time Clock
- Configuring the Reader’s Application Parameters
- Configuring the Reader’s Network Parameters
- Storing the Reader’s Configuration
- Reader - Final Setup
- 95 Series RFID System - Final Test
- Programming and Testing the Transponder T95
- Troubleshooting
- Specifications
- Transponder T95 Messages
- Excitation Modes
- Reader Software Upgrade Procedure
- Glossary
- Index
Setting Up the Exciter’s Address
Configuration and Operation 5-5
2. Check the System Code (SC), by typing:
ISC <Enter>
Theresponseshouldbe:
ISC= [your SC]
If the displayed System Code is not identical with the application system code
number, replace the Reader and report the problem to Lyngsoe.
3. Check the Receiver’s Serial Number (SN), by typing:
ISN [your SN]<Enter>
If the displayed serial number is not equal to the serial number on the Receiver’s
CRM95 board, set it to the correct value. For example, if the SN is U123456, then
type:
ISN=U123456<Enter>
4. Store the new SN and/or SC parameter values, by typing:
:CONFIG:STORE <Enter>
:RESET <Enter>
5. Check the correct values of the IVN, ISC,andISN parameters, by repeating
Steps 1 to 3.
6. Switch off the LF field, by typing:
C<Enter>
SettingUptheExciter’sAddress
Your next step is to setup an address for each Exciter by using the S1 slide switch on
the EXT95SC board, as shown in Figure 5-2 below.
Figure 5-2: Setting Up the Exciter’s Address
E
x
c
i
t
e
r
S
l
a
v
e
E
X
T
9
5
S
C
ON
ADDRESS
"0"
"1"
S1
3210
bit