User's Manual
Table Of Contents
- 95 Series RFID System User’s Guide
- Table of Contents
- List of Figures
- Preface
- Introduction
- Reader R95 Installation and Connections
- Exciter E95 Installation and Connections
- Power Supply TRM95 Installation and Connection
- Configuration and Operation
- Before You Begin
- General Procedure Rules
- Setting Up the Reader/PC Connection
- Reader’s Power-up Sequence
- Learning Procedure (Optional)
- Resetting the Reader
- Checking the Reader’s Basic Parameters
- Setting Up the Exciter’s Address
- LF Transmitter Output
- Configuring the Reader
- Setting Up the Carrier Threshold
- Setting Up the Exciter’s Test-Tag
- Setting Up the Real Time Clock
- Configuring the Reader’s Application Parameters
- Configuring the Reader’s Network Parameters
- Storing the Reader’s Configuration
- Reader - Final Setup
- 95 Series RFID System - Final Test
- Programming and Testing the Transponder T95
- Troubleshooting
- Specifications
- Transponder T95 Messages
- Excitation Modes
- Reader Software Upgrade Procedure
- Glossary
- Index
Setting Up the Programming Site
Programming and Testing the Transponder T95 6-1
Chapter 6
Programming and Testing the Transponder T95
This chapter explains how to setup a site and gives the procedure for programming
the Transponders T95. This chapter does not, however, explain how to choose
parameter values. For more information on configuring the Transponder 95, see the
95 Series RFID System Reference Guide.
Setting Up the Programming Site
Setup the programming site, as shown in Figure 6-1:
Figure 6-1: Programming Site
1. Install Lyngsoe’s T95 Programming Software, Version 2.00 or later on your PC.
For more information on the installation, see the Readme.txt on the installation
diskette.
2. The recommended configuration for the PC’s COM port is:
Data rate - 19200 bps
Data bits - 8 bits
Parity - none
Stop bits - 1
Flow control - none.
3. Set all Transponder T95 parameters using the procedure described in the
Readme.txt file.
PC or Laptop
Slot for T95
DATA LED
DB9-F emale
POWER LED
DB9-Male
Power Supply
9Vac/12to14Vdc
RS232 Cable
Programmer PGM95