User's Manual
Table Of Contents
- 95 Series RFID System User’s Guide
- Table of Contents
- List of Figures
- Preface
- Introduction
- Reader R95 Installation and Connections
- Exciter E95 Installation and Connections
- Power Supply TRM95 Installation and Connection
- Configuration and Operation
- Before You Begin
- General Procedure Rules
- Setting Up the Reader/PC Connection
- Reader’s Power-up Sequence
- Learning Procedure (Optional)
- Resetting the Reader
- Checking the Reader’s Basic Parameters
- Setting Up the Exciter’s Address
- LF Transmitter Output
- Configuring the Reader
- Setting Up the Carrier Threshold
- Setting Up the Exciter’s Test-Tag
- Setting Up the Real Time Clock
- Configuring the Reader’s Application Parameters
- Configuring the Reader’s Network Parameters
- Storing the Reader’s Configuration
- Reader - Final Setup
- 95 Series RFID System - Final Test
- Programming and Testing the Transponder T95
- Troubleshooting
- Specifications
- Transponder T95 Messages
- Excitation Modes
- Reader Software Upgrade Procedure
- Glossary
- Index
Programming Procedures
6-2 Programming and Testing the Transponder T95
4. Power-up the Programmer PGM95 from an AC power supply 9Vac + 10%, 50/60
Hz, or a DC power supply 11 to 14 Vdc. The maximum power supply is 0.5A.
Programming Procedures
Place the Transponder T95 inside the special slot of the PGM95, with the component
side (battery side) down, and gently push it until it is inside the PGM95.
Using T95
Programming
Software
To program the Transponder T95 using Lyngsoe’s T95 Programming Software, start
the software on your PC and follow the programming instructions in the Readme.txt
file.
Using a Terminal
Emulation Program
To use a terminal emulation program, do the following:
1. Open a terminal emulation program, such as Hyperterminal (Windows 95), on
your PC.
2. Set the PC’s COM configuration as described in the section Setting Up the
Reader/PC Connection in Chapter 5. Use this procedure to set and control the
communication between the PC and the Programmer PGM95 (PGM95
incorporates a Receiver CRM95).
3. Use the commands described in the 95 Series RFID System Reference Guide to set
the desired T95 configuration (Group W).
4. Program the T95 using the command: TAG: MATCH (shortcut M).
Confidence Tester TCT95
The Confidence Tester TCT95 is designed to qualify Transponder T95 programmed
with the IPC format, before they are seeded as probe letters into the mail-monitoring
process.
For more information on the Confidence Tester TCT95, see the Confidence Tester
TCT95 User’s Guide.