User's Manual
Table Of Contents
- 95 Series RFID System User’s Guide
- Table of Contents
- List of Figures
- Preface
- Introduction
- Reader R95 Installation and Connections
- Exciter E95 Installation and Connections
- Power Supply TRM95 Installation and Connection
- Configuration and Operation
- Before You Begin
- General Procedure Rules
- Setting Up the Reader/PC Connection
- Reader’s Power-up Sequence
- Learning Procedure (Optional)
- Resetting the Reader
- Checking the Reader’s Basic Parameters
- Setting Up the Exciter’s Address
- LF Transmitter Output
- Configuring the Reader
- Setting Up the Carrier Threshold
- Setting Up the Exciter’s Test-Tag
- Setting Up the Real Time Clock
- Configuring the Reader’s Application Parameters
- Configuring the Reader’s Network Parameters
- Storing the Reader’s Configuration
- Reader - Final Setup
- 95 Series RFID System - Final Test
- Programming and Testing the Transponder T95
- Troubleshooting
- Specifications
- Transponder T95 Messages
- Excitation Modes
- Reader Software Upgrade Procedure
- Glossary
- Index
Transponder T95C
Specifications A-1
Appendix A
Specifications
This appendix gives technical specifications for the Transponder T95, the Reader R95,
the Exciter E95, and the AC Source TRM95. It also gives information on system
performances and special features.
Transponder T95C
LF Receiver • Configuration: Direct detection for 125.0 kHz signals modulated On/Off (OOK)
with 610 Hz.
• Carrier Frequency (125.0 kHz) Bandwidth @3dB:12 to 18 kHz.
• Modulation Frequency (600 kHz) Bandwidth @ 3dBm: 80 to 200 Hz.
• Sensitivity: better than H = 10mA/m[80 dBµA/m] or B=12.6nT in specific test
conditions.
UHF Transmitter • Carrier Frequency, nominal: 433.92 MHz ±50 kHz, stabilized by a SAW resonator.
• Carrier Frequency, max. variation: ±100 kHz, temperature and aging
• Modulation Type: Frequency-Shift Keying (FSK).
• Total Frequency Deviation, nominal: 15 ±3 kHz.
• Total Frequency Deviation, max. variation: 8 to 40 kHz.
• Radiated Power (ERP): less than 10 µW.
• Data Rate: 19.2 or 38.4 kbps.
Excitation Signal The Transponder is only
awaken by signals accepted by the LF Receiver that have a
duration of at least 50ms.
Programming • Mode: optical.
• Data Rate: 1.2 kbps.
• Parameters: see the 95 Series RFID System Reference Guide.
Writing and
Transmitting Data
Asynchronous, NRZ, using a specially developed protocol.
Message Format For more information, see Appendix B, Transponder T95 Messages.
Power Supply 3 V/150 mAh, lithium cell battery.