User's Manual
Table Of Contents
- 95 Series RFID System User’s Guide
- Table of Contents
- List of Figures
- Preface
- Introduction
- Reader R95 Installation and Connections
- Exciter E95 Installation and Connections
- Power Supply TRM95 Installation and Connection
- Configuration and Operation
- Before You Begin
- General Procedure Rules
- Setting Up the Reader/PC Connection
- Reader’s Power-up Sequence
- Learning Procedure (Optional)
- Resetting the Reader
- Checking the Reader’s Basic Parameters
- Setting Up the Exciter’s Address
- LF Transmitter Output
- Configuring the Reader
- Setting Up the Carrier Threshold
- Setting Up the Exciter’s Test-Tag
- Setting Up the Real Time Clock
- Configuring the Reader’s Application Parameters
- Configuring the Reader’s Network Parameters
- Storing the Reader’s Configuration
- Reader - Final Setup
- 95 Series RFID System - Final Test
- Programming and Testing the Transponder T95
- Troubleshooting
- Specifications
- Transponder T95 Messages
- Excitation Modes
- Reader Software Upgrade Procedure
- Glossary
- Index
Table of Contents
Table of Contents 3
Appendix D: Reader Software Upgrade Procedure
UpgradingtheFirmware.....................................D-1
SettingtheReader’sAddress ..............................D-1
SavingParameters.......................................D-2
UsingtheRS232Interface.................................D-2
UsingtheRS485Interface.................................D-3
UsingtheRS485Interface.................................D-3
RestoringParameters ....................................D-4
SettingtheReader’sNetworkConfiguration..................D-4
FinalInstructions .......................................D-5
Glossary.......................................................G-1
Index ..........................................................I-1