User's Manual
Table Of Contents
- 95 Series RFID System User’s Guide
- Table of Contents
- List of Figures
- Preface
- Introduction
- Reader R95 Installation and Connections
- Exciter E95 Installation and Connections
- Power Supply TRM95 Installation and Connection
- Configuration and Operation
- Before You Begin
- General Procedure Rules
- Setting Up the Reader/PC Connection
- Reader’s Power-up Sequence
- Learning Procedure (Optional)
- Resetting the Reader
- Checking the Reader’s Basic Parameters
- Setting Up the Exciter’s Address
- LF Transmitter Output
- Configuring the Reader
- Setting Up the Carrier Threshold
- Setting Up the Exciter’s Test-Tag
- Setting Up the Real Time Clock
- Configuring the Reader’s Application Parameters
- Configuring the Reader’s Network Parameters
- Storing the Reader’s Configuration
- Reader - Final Setup
- 95 Series RFID System - Final Test
- Programming and Testing the Transponder T95
- Troubleshooting
- Specifications
- Transponder T95 Messages
- Excitation Modes
- Reader Software Upgrade Procedure
- Glossary
- Index
Index
Index I-1
Index
A
AC Source TRM95 A-5
C
configuration principles 1-3–1-5
Configuring
Reader’s application
parameters 5-12
D
description
reading points 1-2
response signal 1-2
Transponders 1-2
E
excitation modes C-1
Exciter
assembling the LF antenna 3-2
connecting the power supply 3-5
connecting the RS-485
communication lines 3-3
installing 3-1
LF antenna connections 3-3
setting up addresses 5-5
setting up the test-tag 5-11
tools required 3-1
UHF tranmsitter 3-6
Exciter address 1-5
Exciters
hardware specifications A-4
G
general rules 1-3
H
hardware specifications A-1
L
learning procedure 5-3
LF transmitter output 5-6
M
manual
definitions i
summary i
text conventions i
message format
Transponder B-1
P
parameter settings C-1
parameters
Transponder B-1
Postal RFID System
components 1-3
descripiton 1-3
using 1-2
Power Supply
tools required 4-1
programming site
setting up 6-1
R
Reader 2-1
assembling 2-1
checking parameters 5-4
configuring 5-8
configuring application
parameters 5-12
configuring the network
parameters 5-13
connecting external devices 2-9
connecting the Exciter
communication line 2-6
connecting the power supply 2-7
connecting the RS-232
communication line 2-2
connecting the RS-485 2-wire
communication line 2-3
connecting the RS-485 4-wire
communication line 2-4