User's Manual
Table Of Contents
- 95 Series RFID System User’s Guide
- Table of Contents
- List of Figures
- Preface
- Introduction
- Reader R95 Installation and Connections
- Exciter E95 Installation and Connections
- Power Supply TRM95 Installation and Connection
- Configuration and Operation
- Before You Begin
- General Procedure Rules
- Setting Up the Reader/PC Connection
- Reader’s Power-up Sequence
- Learning Procedure (Optional)
- Resetting the Reader
- Checking the Reader’s Basic Parameters
- Setting Up the Exciter’s Address
- LF Transmitter Output
- Configuring the Reader
- Setting Up the Carrier Threshold
- Setting Up the Exciter’s Test-Tag
- Setting Up the Real Time Clock
- Configuring the Reader’s Application Parameters
- Configuring the Reader’s Network Parameters
- Storing the Reader’s Configuration
- Reader - Final Setup
- 95 Series RFID System - Final Test
- Programming and Testing the Transponder T95
- Troubleshooting
- Specifications
- Transponder T95 Messages
- Excitation Modes
- Reader Software Upgrade Procedure
- Glossary
- Index
List of Figures
List of Figures 1
List of Figures
Figure1-1:RFIDConcept...........................................................1-1
Figure 2-1: Connections and Jumper Settings for the RS-232 - PC Communication Line . . . . . . . . 2-2
Figure 2-2: Connections and Jumper Settings for the RS-485 Two-Wire Communication Line . . . . 2-3
Figure 2-3: Connections and Jumper Settings for the RS-485 Four-Wire Communication Line . . . 2-5
Figure2-4:ConnectionsandJumperSettingsfortheExciterCommunicationLine.............2-6
Figure2-5:PowerSupplyConnections.................................................2-8
Figure2-6:ExternalDevicesConnections..............................................2-9
Figure3-1:LFAntennaConnections ..................................................3-3
Figure 3-2: Connections and Jumpers Settings for the RS-485 Communication Lines . . . . . . . . . . . 3-4
Figure3-3:ExciterE95PowerSupplyConnections.......................................3-5
Figure5-1:ConnectingtheReadertoaPC/Laptop.......................................5-2
Figure5-2:SettingUptheExciter’sAddress............................................5-5
Figure5-3:LFSignalMeasurement...................................................5-6
Figure6-1:ProgrammingSite........................................................6-1