User's Manual
Table Of Contents
- 95 Series RFID System User’s Guide
- Table of Contents
- List of Figures
- Preface
- Introduction
- Reader R95 Installation and Connections
- Exciter E95 Installation and Connections
- Power Supply TRM95 Installation and Connection
- Configuration and Operation
- Before You Begin
- General Procedure Rules
- Setting Up the Reader/PC Connection
- Reader’s Power-up Sequence
- Learning Procedure (Optional)
- Resetting the Reader
- Checking the Reader’s Basic Parameters
- Setting Up the Exciter’s Address
- LF Transmitter Output
- Configuring the Reader
- Setting Up the Carrier Threshold
- Setting Up the Exciter’s Test-Tag
- Setting Up the Real Time Clock
- Configuring the Reader’s Application Parameters
- Configuring the Reader’s Network Parameters
- Storing the Reader’s Configuration
- Reader - Final Setup
- 95 Series RFID System - Final Test
- Programming and Testing the Transponder T95
- Troubleshooting
- Specifications
- Transponder T95 Messages
- Excitation Modes
- Reader Software Upgrade Procedure
- Glossary
- Index
Index
I-2 Index
power-up sequence 5-3
resetting 5-4
storing the configuration 5-13
reader address 1-4
Reader data handling 1-4
Reader serial port 1-4
Readers
communicating with
Transponders 1-2
hardware specifications A-2
system performance A-5
reading points
description 1-2
real time clock 1-4
related manuals ii
response signal
description 1-2
RFID System
configuring 5-1–5-16
self testing capabilities A-6
S
setting up carrier threshold 5-9
setting up the Reader/PC
connection 5-2
setting up the Real Time Clock 5-12
system code 1-4
system performance
Readers A-5
Transponders A-5
T
testing
System 95 5-14
text conventions ii
Transponder
message format B-1
parameters B-1
programming 6-1–6-2
programming procedure 6-2
Transponder Identification System
purpose 1-1
Transponders
communicating with Readers 1-2
decription 1-2
examples 1-2
hardware specifications A-1
system performance A-5
Troubleshooting 7-1–7-8
U
UHF data receiving 1-4
upgrade procedures
upgrading the firmware D-1
upgrading procedures
final instructions D-5
restoring parameters D-4
saving parameters D-2
setting the Reader’s address D-1
setting the Reader’s network
configuration D-4
using the RS232 Interface D-2
using the RS485 Interface D-3