User's Manual

Configuring the Reader’s Network Parameters
5-14 Configuration and Operation
Configuring the Reader’s Network Parameters
To configure the Reader’s network parameters, do the following:
1. Set the reporting mode, by typing:
DAR=N<Enter>.
2. Set the Reader’s address, by typing:
IAD=r<Enter>
where r is the Reader’s address. The lowest value for this address is 1. For example, if there are
4 Readers in a network, they must be assigned the following addresses 1, 2, 3 and 4.
Storing the Reader’s Configuration
To store the Reader’s configuration, do the following:
1. Store the Reader’s parameters, by typing:
:CONFIG:STORE<Enter>
2. Reset the Reader, by typing:
:RESET<Enter>
Note The:CONFIG:STORE command stores the current Reader’s configuration in the non-volatile
memory.
The:RESET command updates the contents of the working memory from the non-volatile
memory.
3. Check whether the Reader is operating properly, by typing:
@r IVN<Enter>
where r is the Reader’s address. The Reader must respond with its software version number.