User's Manual

Lyngsoe Systems Exciter EX23G
950115B.pdf Page 2 of 7
1. General
Exciter EX23G is designed to operate either as a stand alone exciter or as a unit in a multi-drop
asynchronous network (RS485). When it’s connected to a network it shall be programmed with an
unique address (NetId).
Exciter EX23G provides the following main functions:
-Remote control/configuration using a RS485 communication network;
-Rotating LF excitation field, using a dual loop antenna system;
-LF excitation field generation controlled optionally by a motion sensor
-Wireless supervision, using 434MHz UHF channel;
-Optical signalization
2. Installation
This chapter explains how to power up and interconnect the Exciter EX23G. Typical
installation of the Exciter EX23G is presented in the figure 2-1 and the connector location in
figure 2-2
Figure 2-1 Exciter EX23G installation