User's Manual

Lyngsoe Systems Exciter EX23G
950115B.pdf Page 6 of 7
EVT R/W 1…100 10
Reserved for authorized personnel only
EPS R/W S/P/A S
Reserved for authorized personnel only
ENF R/W 0, 1…7 5
Reserved for authorized personnel only
EP1 R-EV1 1…127 n/a
Reserved for authorized personnel only
EA1 R-EV1 1…127 n/a
Reserved for authorized personnel only
EP2 R-EV2 1…127 n/a
Reserved for authorized personnel only
EA2 R-EV2 1…127 n/a
Reserved for authorized personnel only
EMN R 0-15 n/a
Number of MS activations on the exciter EX23 between either
2 consecutive transmissions on UHF or 2 consecutive
executions of the command EMN.
EMS R/W Y/N N
Motion Sensor enable(Y) / disable(N)
EMD R/W 1…9 5
Extra field generation duration after the Motion Sensor has
been activated
ERD R/W Y/N N
Turn On/Off (Y/N) the red lamp
EGR R/W Y/N N
Turn On/Off (Y/N) the green lamp
ERS R 0…255 n/a
Number of power-on resets between two commands ERS
Note1: (*) Par. type: R – read only; R/W – read & write; R-EVx – Read only through the EVx
command
A parameter can be set by transmitting the 3-letters name of the parameter and its value, as in the
following syntactical expression: #NetId<space><Parameter name>=<value><CR>
The actual values of the parameters can be queried using the 3-letters name of the parameter, as
in the following syntactical expression: #NetId<space><Parameter name><CR> Note2: The
address 254 can be used to report information about an exciter with unknown address, as shown in
the following syntactical expression: #254<space>Q<CR>