User's Manual

Lyngsoe Systems Combi RFID Master MC30RG
Doc no. 950237 - Page 3 of 14
1. General
Combi RFID Master MC30RG is a combined unit that can operate completely independent as an RFID Portal
that is able to read RFID active tags on 125 kHz/434MHz as well as passive tags on 868/915MHz (see
Appendix 1 for active and passive tags examples). After reading, the incorporated Single Board Computer
(SBC) can filter the relevant readings and can report them over a wireless GSM / GPRS link to a central
database for processing. The marketing name for MC30RG is LS4230 – this name is printed on the front
label.
Figure 1 - General view
2. MC30RG Description
On the top side of the MC30RG portal there is a cover that needs to be removed in order to connect the unit to
power and wired RS485 communication lines. Place the portal on a flat surface with the cover up. If the
passive antennas are installed, it is recommended to place the portal transversal on a narrower work table
with the top cover up such that the two passive antennas hang in the open space.
Remove the plastic quarter-turn screws and lift the cover.
Figure 2 - Cover removal for MC30RG
Remove the four plastic screws
using a coin or a flat screwdriver
10-20mm wide.
Cover
Power
Cable
RS485
Cable