User's Manual

Lyngsoe Systems PR34X- RFID Reader
950XXX_.pdf Rev: 1.0 Page 3 of 4
3. Installation:
Installation and maintenance of the product is the sole responsibility of the Airline.
(Installation procedures to be provided by Airline). Equipment is to be mounted in a
secure way to ensure equipment cannot fall off or be easily knocked off. Mounting
brackets and mounting bracket designs are the responsibility of the airline and or Belt
Loader Manufacturer. It is recommended that the Airline and or Belt Loader Manufacturer
consult with Lyngsoe Systems regarding mounting bracket design, placement and best
practices to ensure optimum performance and compliance to FCC rules.
The unit comes with a standard wire harness.
Custom wire harnesses can be provided on request. A fee will be charged for this service.
Mounting instructions are to be provided by the airline, airline systems integrator or belt
loader manufacturer and approved by Lyngsoe Systems Ltd.
Regarding Antenna installation: The antenna must be installed at a separation
distance of at least 32 cm from all persons, and must not be co-located or operation
in conjunction with any other antennas or transmitters.
4. Operation
Operation and function is specific for each application. Lyngsoe Systems and or its partner
will provide approved middleware for relaying capture data to user application. Details and
middleware performance are out of scope of this manual.
Radio module performance is limited to meet FCC and network provider requirements.
They are not accessible or controllable by the end user.