User's Manual

Lyngsoe Systems RFID Reader and Exciter PRX23
950409 Page 6 of 8
To assign a static IP address, type IIP=”x.x.x.x” where x.x.x.x is the IP address, and
press Enter. You should see
OK
IIP=” x.x.x.x”
Type :CONFIG:STORE and press Enter, to store the new IP address. You should see:
OK
00
Then, type :RESET and press Enter. You should see:
PRX23, Lyngsoe Systems Ltd. (c)
b. Use DHCP to get an IP address
Make sure the network cable is connected. Type IDH=Y and press Enter to select
“dynamic IP mode”. You should see:
OK
IDH=Y
Type :CONFIG:STORE and press Enter. You should see;
OK
00
Type :RESET and press Enter. You should see
PRX23, Lyngsoe Systems Ltd. (c)
Type IIP and press Enter to read the IP address. You should see:
OK
DHCP IP Address: x.x.x.x
where x.x.x.x is the IP address assigned to the PRX23. If the PRX23 power is cycled, the
dynamic IP address may change.
After the IP address has been set, the reader is ready to communicate over Ethernet; for
testing, you can use Hyper Terminal again. To do this, follow the steps below:
3. Operation
Every time a tag message is received it will be shown on the RS485 or Ethernet console if
the tag dumping function is enabled. The following is an example:
{TS="0905191637Z",LI=-62,UD="C\xFD\x00\x08\x02",EX="\x7F",CT="\x00",FG="HI"}