User's Manual

PT40A Postal Tag RFID-LSCAN
Page: 5 of 6
Programmer UP23 box. The tag will not transmit if it enters an LF field but the excitation pattern cannot be recognized (i.e.
overlapping fields or interference).
4 REGULATORY COMPLIANCE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of more of
the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
4.1.1 Maximum Transmission Time
To comply with 15.231(a) of FCC regulations, the maximum transmission time of PT40A in Excitation mode must not exceed 5
seconds.
To minimize collisions in an application, PT40A tags are programmed with random values for the WSD parameter, which
ensures that inter-message durations are randomized differently for individual tags. To ensure sufficient transmission redundancy
in an application a certain optimum number of transmitted messages is selected and programmed into the WIP+WRC parameters.
The sum of both parameters represents the number of messages transmitted in a burst and this affects the overall transmission
duration.
In our typical application WIP + WRC = 20 and WSD = 7 and the resulting average transmission time is around 2s. If we set
maximum values for these parameters WIP + WRC = 30 and WSD = 30 the resulting transmission time is 4.3s so PT40A still
complies with the FCC requirements for maximum transmission time.