User's Manual

Lyngsoe Systems RFID Rd/Ex XR30

950213-.doc Page 2 of 5

1. General

RFID Rd/Ex XR30 is basically an RFID Exciter EX30 which incorporates also a Reader

RD23. It can operate as an RFID Exciter and Reader to excite RFID Tags and to receive

their UHF messages.

RFID Rd/Ex XR30 as a combined unit provides all the functionalities documented for the

EX30 and RD23 units. These functionalities and technical specifications are completely

described by the following documents:

- RFID Exciter EX30 User Guide - doc 950212-.pdf;

- Exciter Board EXB30, Functional Specification – EXB30FSrC.pdf;

- RFID Reader RD23, User Guide – doc. 950214-.pdf;

- RFID System S23, Reference Guide – doc S23ReferenceGuide.pdf;

- Reader RD23, Technical Specification – doc RD23Description-IC.pdf

The marketing name for XR30 is LS4000 – this name is printed on the front label.

2. Installation

Installation of the XR30 unit is quite similar with the description provided for the Exciter

EX30 and RD23. Typical installation of the XR30 is presented in the figure 2-1; all the

external connections are accessible inside the unit as presented in figure 2-2.

Figure 2-1 Exciter EX30 installation

2.1. EX30 Connections

Power Connections

WARNING! Before you start the installation, check if the Power Supply provides the

specified output voltage – 24Vdc +/- 10%, and min. 1A; for the power connections use the

4.2mm Mini-Fit Jr receptacle (LS PN 350238) and the female crimp terminals for

AWG18-24 (LS PN 350238). Strip the wire isolation 3.0-3.5 mm and crimp the terminals

on the wire using the Molex crimping tool 11-01-0197. Insert the terminals in the

EX30

Power

Cable

RS485

Cable

Power

ON LED

Field ON

LED

Motion

Senso

Isolated

Chains