User's Manual

Lyngsoe Systems RFID Rd/Ex XR30

950213-.doc Page 5 of 5

serial communication program like Procomm, through a serial communication link type RS485.

There are several specific commands to configure or to query the XR30 parameters values.

XR30 has a unique address called NetId. The NetId is an integer in the range 0 to 127 and is a good

practice to clearly mark it on the front label in the designated area.

Readers can be controlled using the syntax:

@NetId <space><COMMAND> <CR>; the prefix #NetId is separated from the command itself

by a space.

Exciters can be controlled using the syntax:

#NetId <space><COMMAND> <CR>; the prefix #NetId is separated from the command itself

by a space.

4. Commands and Parameters

For the complete list of commands and parameters accepted by the Exciter see documentation for

Exciter EX30, and for the Reader see documentation of Reader RD23.

FCC compliance

Caution:

Changes or modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

Part 15.105 Information to the user

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.