Installation Manual

ManualsBrandsLynk ManualsHome & KitchenLynk 24 Pair Over Door Shoe Rack - White

STEP 5: Guide each tube into

socket and gently tap

to hold in place.

STEP 2STEP 1 STEP 3

Assemble on

solid surface

STEP 2:

STEP 8: Lay completed assemblies end to end facing the

same direction.

Firmly hammer tubes into each

of the eight (8) sockets.

Hammer tubes all

the way into sockets.

Line up tubes with sockets.

CURVES OF SIDES MUST FACE

IN THE SAME DIRECTION

ONCE TUBES ARE FIRMLY IN SOCKETS,

DO NOT ATTEMPT TO REMOVE.

Rotate clockwise, turning assembly over.

STEP 3:

TURN PAGE OVER FOR REMAINING STEPS

Repeat Steps 2-6 with

remaining sides and tubes.

VERY IMPORTANT!

ATTENTION: Assemble all parts on a solid surface (not carpet) or damage will occur!

OVERDOOR SHOERACK PARTS LIST

Hanging Brackets (2)

Frame Sides (6)

Steel Tubes (24)

STEP 5

STEP 4

STEP 4:

CURVES OF SIDES

MUST FACE IN

SAME DIRECTION

STEP 6

STEP 6:Firmly hammer tubes all the

way into sockets. If this is

not done, the product

will not stay together.

STEP 7

STEP 8

Assemble all parts on a smooth, hard

surface such as wood or concrete.

The ends of the steel tubes

are intentionally indented to

ease assembly.

Indentation

Firmly hammer tubes all the

way into each socket. If this

is not done, the product will

not stay together.

DO NOT assemble

on soft surfaces

such as carpet

or damage will

occur.

Summary of content (2 pages)

PAGE 1
ATTENTION: Assemble all parts on a solid surface (not carpet) or damage will occur! STEP 1 VERY IMPORTANT! STEP 2 STEP 4 STEP 3 Assemble all parts on a smooth, hard surface such as wood or concrete. DO NOT assemble on soft surfaces such as carpet or damage will occur. CURVES OF SIDES MUST FACE IN SAME DIRECTION Hammer tubes all the way into sockets. Indentation The ends of the steel tubes are intentionally indented to ease assembly.
PAGE 2
DO NOT TAP FROM TOP! STEP 9 6 Optional Installations STEP 10 For doors thicker than the standard 1-3/8”: Bend bracket at the top score line until back portion breaks off. Then mount to oversized door as shown. To mount to a wall or surface: STEP 9: By hand, press the assemblies together to hold in place. STEP 10: Tap connections together as shown, on a firm surface only. Bend bracket at front score line until top portion breaks off. Then mount to wall or surface as shown.