Installation Guide

Remove packing materials

Remove tape from glides (4 places)

Glide

Frame

Remove

Tape

(4 places)

Set drawer onto glide-frame with

drawer mounting holes aligned.

Check for adequate cabinet and

door clearance.

Adjust glide frame position if necessary.

Drawer

Parts Bag Includes:

Instruction Sheet

Alignment Guide

Drawer mounting screws (4)

Wood screws (4)

“

min.

“

min.

Make sure glide-frame

is facing to the front as

indicated by arrows.

Alignment

Guide

2 ”

min.

Use alignment guide found in parts

bag to align glide-frame inside of

cabinet as shown.

, Inc. 8241 Melrose Drive, Lenexa, KS 66214

051106T

Roll-Out Drawer If you have questions, please call 800-733-5965

PAGE 1
Remove packing materials Remove tape from glides (4 places) Remove Tape (4 places) Drawer Parts Bag Includes: Instruction Sheet Alignment Guide Drawer mounting screws (4) Wood screws (4) Glide Frame 2 Use alignment guide found in parts bag to align glide-frame inside of cabinet as shown. 3 Set drawer onto glide-frame with drawer mounting holes aligned. Check for adequate cabinet and door clearance. Adjust glide frame position if necessary. “ 2” “ 2 min. min. 2 min.
PAGE 2
4 Remove drawer from glide-frame. Move glide rails slightly forward as shown and install glide-frame into cabinet using wood screws found in parts bag. Recommended. Install front screws first Move glide forward 2” “ 2 min. min. Drill 4 starter holes using an 1/8” diameter drill bit. The use of a power screwdriver. 5 “ Recommended: 2 min. Set drawer back onto glide-frame with mounting holes in drawer and glide-frame aligned.