Installation Guide

Glide

Tool

Loops (4)

Parts Bag

Discard (2)

Assemble

Unpack

Discard (4)

Tighten

Finger Nut

Base

Loop (4)

Finger

Nut (8)

Attach loops to base using nger nuts.

Using tool provided, securely tighten nger nuts.

•

Roll-Out Lid Holder

If you have questions, please call 800-733-5965

012507-REV D

Parts Bag Includes:

Finger Nuts (8)

Mounting Screws (4)

Wood Screws (4)

Tool

Instructions

Alignment Guide

PAGE 1
Unpack Discard (4) Discard (2) Parts Bag Includes: Finger Nuts (8) Mounting Screws (4) Wood Screws (4) Tool Glide 2 Base Loops (4) Parts Bag • Instructions • Alignment Guide Assemble Attach loops to base using finger nuts. Loop (4) Base Finger Nut (8) 3 Tighten Using tool provided, securely tighten finger nuts. Finger Nut Tool Roll-Out Lid Holder 012507-REV D If you have questions, please call 800-733-5965 © 2007 Lynk ®, Inc.
PAGE 2
4 5 Align Use allignment guide found in parts bag to allign glide-frame inside of cabinet as shown. Check Set the assembled loops and base onto glide-frame with mounting holes alligned. Allignment Guide 2”min. 2”min. 2”min. 6 Check for adequate cabinet and door clearance. Make sure arrows are pointing to the front of the cabinet. Adjust glide frame position if necessary. Install Remove loops and base from glide-frame.