Installation Guide

Insert the 4 Long Screws into the

Upper Drawer corner tubes and tighten

using the L-shaped wrench.

Connecting

Rod

Place Upper Drawer...

Corner

Tube

onto connecting rods by inserting the

rods into the corner tubes.

Lower Drawer Indicated by

Mounting Plates

Secure Upper Drawer

Use L-Shaped Wrench

to tighten screws until snug.

Thread Connecting Rods...

into lower drawer by hand-screwing into

tubes.

Lower drawer indicated

by mounting plates.

Tighten Connecting Rods...

using at wrench on at spot near

top of rods.

Flat Spot

Note: Face drawer fronts

in same direction.

Glide

Parts Bag

Parts Bag Includes:

Long Screws (4)

Mounting Screws (4)

Wood Screws (6)

Flat Wrench

L-Shaped Wrench

Instructions

Alignment Guide

Unpack

Lower Drawer

Roll-Out Double Drawer 012507-REV C

If you have questions, please call 800-733-5965

Upper Drawer

Connecting

Rods

•

PAGE 1
Unpack Parts Bag Includes: Lower Drawer Indicated by Mounting Plates Long Screws (4) Mounting Screws (4) Connecting Rods Wood Screws (6) Flat Wrench Upper Drawer Parts Bag 2 Lower Drawer Glide Thread Connecting Rods... into lower drawer by hand-screwing into tubes. • • 3 Instructions Alignment Guide Tighten Connecting Rods... using flat wrench top of rods. on flat spot near Flat Spot Lower drawer indicated by mounting plates. 4 L-Shaped Wrench Place Upper Drawer...
PAGE 2
6 Align Use alignment guide found in parts bag to align glide-frame inside of cabinet. 7 Check Set the assembled double drawer onto glide-frame with mounting holes aligned. Alignment Guide 2”min. 2”min. 2”min. 8 Check for adequate cabinet and door clearance. Make sure arrows are pointing to the front of the cabinet. Adjust glide frame position as needed. Install Remove assembled drawers from glide-frame.