Refrigerator Manual

FIGURE 1 (Normal position) FIGURE 2 (Position after door reversal)

1 Top Hinge

2 Screw (3)

3 Door

4 Bottom Hinge

5 Screw (3)

6 Frame

7 Hole Cover

* Insert the lower door hinge in the right side, fix the lower right hinge by tightening all the

screws.

* Remove the pin cap from the right side of the upper frame of the door, and then transfer it to

the same location on the opposite side.

* Put the door on the Lower Door Hinge(5), keep the door level , and then fix the upper hinge(3)

to the body(4) by the screws

* Put on the upper hinge cover(1).

OPERATING YOUR UNIT

Setting the Temperature Control

* Your unit has only one control for regulating the temperature in the compartment. The tempera ture con-

trol is located on the top center of the compartment.

* The first time you turn the unit on, set the temperature control to “5”.

* The range of the temperature control is from position "OFF” to “5”. After 24 to 48 hours, adjust the tem-

perature control to the setting that best suits your needs. The setting of “3” should be appropriate for

normal use.

* To turn the appliance off, turn the temperature control to ”OFF”.

NOTE:

* Turning the temperature control to “OFF” position stops the cooling cycle but does not shut off the

power to the unit.

* If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes before restarting

the unit. If you attempt to restart before this time delay, the unit will not start.