Use & Care Manual

P a g e | 15
then ‘time out’. This is part of the safety system. If this occurs, simply turn the wall switch to OFF, and then turn
back to ON. The spark will return to its normal function. Repeat this operation until the pilot lights. Once the pilot
lights, the heater will light within seconds.
4. ALSO NOTE: when the heater is operated for the first time, there may be a certain level of smoke exiting the heater
exhaust vents. This may last for up to 15 minutes. This is NORMAL. This is a result of the manufacturing oils, cleaning
oils, and anti-seize lubricants, burning away under high temperature for the first time. After this ‘break-in’ period,
your heater should function normally, emitting no additional smoke.
Touch Screen Remote Control Operation
Before attempting to operate your remote, you must be sure that the remote control has been ‘initialized’ or paired
with the receiver. Please see the section of this manual titled ‘Initializing the Remote Control System ’, page 13.
Changing from Degrees Fahrenheit (F) to Degrees Celsius (C)
 When the remote control is OFF, the current air temperature is displayed in the upper right hand corner of the
display window. This temperature will read either in degrees Fahrenheit (F) or degrees Celsius (C). To alternate
and change between degrees (F) and degrees (C), with the remote in the OFF position, simply press the DOWN
arrow key and the UP arrow key at the same time briefly. Use a short click and do not hold the buttons down
continuously. Please refer to the diagram ‘Touch Screen Remote Control Layout’, page 16, for reference.
Day and Time Display
 The current day of week and time of day will be continuously displayed in the TIME/PROG Zone (except during
Setup operations).
 The day of week will be displayed as one of the following: S, M, T, W, T, F, S
 The time of day will be in 12-hour AM, 12-hour PM format. Midnight will be displayed as 12:00am.
 Day/Time Setup-Turn Operation Mode to OFF By pressing the MODE/ SET button at bottom:
o Press and hold the MODE Zone or the MODE/SET Button for 5 seconds to enter Day/Time Setup.
o Press the UP or DOWN Buttons to adjust the day of week (press the MODE/SET Button or wait for 15
seconds for adjustment to be accepted, then enter hour of day adjustment).
o Press the UP or DOWN Buttons to adjust the hour of the day. The time will advance in 1-hour
increments; AM and PM will change when the hour advances to 12:00 midnight and 12:00 noon
respectively (press the MODE/SET Button or wait for 15 seconds for adjustment to be accepted, then
enter minute of hour adjustment).
o Press the UP or DOWN Buttons to adjust the minute of the hour. The time will advance in 1-minute
increments (press the MODE/SET Button or wait for 15 seconds and the transmitter will exit Day/Time
Setup and return to normal operation).
o LCD Displays – when in Day/Time Setup:
 MODE Zone: Blank
 ROOM/AIR TEMP Zone: Blank
 SET TEMP Zone: Bank
 LIGHT Zone: Blank
 FAN Zone: Blank
 TIME/PROG Zone: Day of Week, or Time of Day will Flash
 AUX Zone: Blank
 FLAME Zone: Blank