Use & Care Manual

P a g e | 17
MANUAL OFF Mode:
 Transmits heater OFF command.
 LCD Displays:
o MODE Zone: OFF is displayed
o ROOM /AIR TEMP Zone: Measured temperature is displayed
o SET TEMP Zone: Blank
o TIME/PROG Zone: Current day indicator and current time is displayed
o FLAME Zone: Blank
MANUAL ON Mode:
 Transmits Heater ON command
 LCD Displays:
o MODE Zone: ON is displayed
o ROOM/AIR TEMP Zone: Measured temperature is displayed
o SET TEMP Zone: Blank
o TIME/PROG Zone: Current day indicator and current time is displayed
o FLAME Zone: the FLAME-‘A’ Icon is displayed
Adjusting Heat Level: during MANUAL ON mode, the heat level can be adjusted to 6 levels of heat increments for NG
applications. (3 levels for LP applications). To adjust heat level, select “ON’ mode, and allow the heater to cycle on.
Press and hold flame level ‘A’ on the touch screen (the larger flame icon) until the flame flashes. The current heat level
will be displayed #1 through #7. Press the UP arrow button at the bottom to raise the heat level. Likewise, press the
DOWN arrow to LOWER the heat level. The heater will immediately respond as the heat level is adjusted on the remote
control. NOTE: be sure that the LARGER flame icon (labeled ‘A’) is selected when adjusting the heat level. The smaller
flame icon ‘B’ is not used for this adjustment. Also NOTE: when using the touch screen remote, the last heat setting
used as the heater was turned off will be remembered by the remote. As the heater is turned back on, it will resume
heating at the previous level. If the wall switch is used to turn ON the heater, it will always light on HIGH.
THERMOSTAT Mode:
 Thermostat Mode will cycle heater on and off based on air set temperature seen directly at the remote control.
The remote control will transmit the ON command when SET TEMP is set 2 degrees higher than AIR/ROOM
TEMP, and will transmit OFF command when SET TEMP becomes 2 degrees lower than ROOM TEMP. This 2
degrees is known as ‘swing temperature’, and can be adjusted. (see SWING temperature below).
 Built-in thermostat will measure air temperature.
 SET TEMP: While in THERMOSTAT mode, press the UP or DOWN Button to change the SET TEMP (45-99 deg. F,
7-37 deg. C); the new set temperature will automatically be accepted after 2 seconds. NOTE: THERMO OFF will
be read in the upper MODE set window until the set temperature is set to a level (2 degrees) higher than air
temperature (this is called SWING TEMPERATURE). Then, this will change to THERMO ON.
 SWING Temperature:
o Factory default is 2 degrees F (1 deg. C).
o To change this 2 degree default, press and hold the SET TEMP Zone for 5 seconds to enter SWING
Adjustment, and press the UP and DOWN Buttons to adjust the SWING temperature from 3 degrees F (2
degrees C) or to 1 deg. F (still 1 deg. C) (press the MODE/SET Button or wait for 15 seconds for the new
setting to be accepted).
o LCD Display - When in SWING Adjustment:
 MODE Zone: Blank
 ROOM/AIR TEMP Zone: Blank
 SET TEMP Zone: S1, S2, or S3 (number equals swing temperature) in place of SET temperature