Use & Care Manual

P a g e | 19
o ROOM/AIR TEMP Zone: Measured temperature is displayed
o SET TEMP Zone: Blank
o TIME/PROG Zone: Current day indicator, current time, and Program status (P1-OFF or P2-OFF) is
displayed
o FLAME Zone: Blank
o
 Program ON LCD Displays:
o MODE Zone: THERMO and either ON or OFF is displayed
o ROOM/AIR TEMP Zone: Measured temperature is displayed
o SET TEMP Zone: SET TEMP is displayed
o TIME/PROG Zone: Current day indicator, current time, and Program status (P1-ON or P2-ON) is displayed
o FLAME Zone:
 If Thermostat is ON, the Flame-A Icon is displayed.
 If Thermostat is OFF, display is blank.
Program Mode Activation (advanced operation only)- SKIP THIS SECTION FOR BASIC REMOTE CONTROL OPERATION
A short push of (PROG/ TIME) button will select/operate or de-activate the PROGRAM mode. A long push (push & hold
for more than 5 seconds) of this button will enter into the Setting of PROGRAM mode. Following are the Factory settings
for the PROGRAM mode:
M T W T F
Segment 1(P1) ON - 7:00am OFF 9:00am
Segment 2(P2) ON - 5:00pm OFF 8:00pm
S S
Segment 1(P1) ON - 9:00am OFF - 10:00am
Segment 2(P2) ON - 6:00pm OFF - 9:00pm
Following is the set up for the Program Mode:
Push & hold button for more than 2 seconds to enter the setting for program mode:
M T W T F & & on LCD will flash, then you can use UP or DOWN
keys to change the setting of “P1 ON". Then you push SET button to enter into next setting.
M T W T F & & on LCD will flash, then you can use UP or DOWN to
change the setting of “P1 OFF". Then, push SET button to enter into next setting.