Use & Care Manual

P a g e | 20
M T W T F & & on LCD will flash, then you can use UP or DOWN to
change the setting of “P2 ON". Then, use SET button to enter into next setting.
M T W T F & & on LCD will flash. Then use UP or DOWN to change
the setting of “P2 OFF". Then, push SET button to enter into next setting.
S S & & on LCD will flash, then you can use UP or DOWN keys to
change the setting of “P1 ON". Then you push SET button to enter into next setting.
S S & & on LCD will flash, then you can use UP or DOWN to change
the setting of “P1 OFF". Then, push SET button to enter into next setting.
S S & & on LCD will flash, then you can use UP or DOWN to change the
setting of “P2 ON". Then, use SET button to enter into next setting.
S S & & on LCD will flash. Then use UP or DOWN to change the
setting of “P2 OFF". Then, push OK button to enter into next setting.
NOTE: The “flashing” stated above for the PROGRAM setting will only last for 2 Minutes. If SET button (or any other
buttons) is not pushed within this period, the system will automatically complete the “PROG/TIME setting” process and
the LCD will go back to its normal readouts.
IMPORTANT NOTE TO UNDERSTAND:
The control of the appliance will be under the SET TEMPERATURE of the thermostat. If the SET temperature is at
"45F" as it comes from the factory, the appliance will not turn ON if the air temperature is higher than the SET
temperature. If the SET temperature is at "70F", the appliance will come on only if the air temperature is below
"70F". The mode of this transmitter can be either in OFF or THERMO, and the PROGRAM will still operate.