Installation Guide

Page 1 of 1 P/N 11863.00 Rev A
LOHI
INSTALLATION INSTRUCTION
CAUTION: Before installing ventilator read the HOOD INSTALLATION
INSTRUCTIONS.
PARTS INCLUDED: 1 - Ventilator Assembly
4 - #8 x ½ Pan Head SMS
1 – Wire Harness (#33896)
1 – Wire Tie
A
1) Install Hood & Transition per hood installation instruction.
2)
Remove parts from carton. Remove all corrugated packaging shims between motor and
housing.
3) Rotate ventilator wheels to confirm they rotate freely.
4) Connect Wire Harness #33896 to Hood Receptacle Box.
5) Install ventilator per HOOD INSTALLATION INSTRUCTION using 2- screws.
6) Connect Ventilator to Hood Receptacle Plug on Front Panel using Wire Harness #33896, (if required
excessive wires shall be attached to blower body flange notch at point - A using wire tie, twist wire 3
to 4 times to secure excess wire – see picture).
7) Check operation of ventilator per HOOD INSTALLATION INSTRUCTIONS.
IC
GREY
BLACK
BLUE
YELLOW
WHITE
RED
BLUE
RED
YELLOW
WHITE
MOTOR
MOTOR
WHITE
BLUE
YELLOW
RED
WHITE
WHITE
WHITE
WHITE
BLUE
WHITE
BLACK
RED
WIRE HARNESS
P/N 33896
LOHI
WIRING
YELLOW - LO
RED - MED
BLUE - HI
WHITE - COM
RED - LO
WHITE - COM
BLUE - MED
BLACK - HI
BODY
GREEN
GREEN
TO HOOD
RECEPTACLE
PLUG
BLACK
GREY
IC
Lynx Professional Grills
6023 E. Bandini Blvd.
Commerce, CA 90040
Service: (888) Buy-Lynx
(888-289-5969)
www.lynxgrills.comwww.lynxgrills.com Fax: [phone]