Manual

Sonoma Smoker By Lynx™ Care & Use P/N 35948 Page 17
GAS CONNECTIONS…(connued)
Always leak test the connecon aer relling or exchanging
liquid propane cylinders. (See INDEX: “Leak Test” for further
details.)
ELECTRICAL CONNECTIONS
WARNING: ELECTRICAL GROUNDING
Product installaon must meet local electrical codes, or in the absence of local codes, the latest edion of the Naonal Electrical
Code ANSI/NFPA No. 70 or the Canadian Electrical Code CSA C22.1.
Use only a Ground Fault Interrupter (GFI) protected circuit with this outdoor cooking gas appliance.
Do not use this outdoor cooking appliance if it has been submerged underwater without a thorough inspecon by a qualied
technician.
This smoker is equipped with a three-prong (grounded) electric plug for your protecon against shock hazard and must be
plugged directly into a properly grounded three-prong outlet. Never cut or remove the grounding prong from this plug.
Use only extension cords with a three-prong grounding plug, rated for the power of the equipment and approved for outdoor use
with a “W-A” marking.
To protect against electric shock, do not immerse any part of the power cord, an extension cord, or any plugs in water or other
liquid.
Unplug the product before thorough cleaning. Allow it to cool before pung on or taking o parts.
Do not let the cord hang over the edge of a table or touch hot surfaces.
Do not use an outdoor cooking gas appliance for purposes other than intended.
Do not operate any outdoor cooking gas appliance with a damaged cord, plug, or aer the appliance malfuncons or has been
damaged in any manner. Contact Lynx for repair.
Gas Line Purging
You should purge the gas line of air before aempng to light the
oven.
 Make sure all oven controls are in the “OFF” posion.
 Disconnect the line from the manifold. Slowly turn on the
main gas supply.
 As soon as you smell gas, shut o the supply
 Reconnect the line, and test for leakage.
 Turn the supply back on slowly.
 Wait at least 5 minutes before aempng to light the burner.
Liquid Propane Connecons
Make sure the liquid propane cylinder valve is completely
closed. It is possible for the valve to be opened without
releasing gas, but as soon as you start connecng the regulator,
gas can ow from the connecon.
Insert the regulator inlet into the cylinder valve and turn the
black coupler clockwise unl the coupler is hand ght. Do not
over-ghten this connecon.
To disconnect the coupler, rst make sure the main cylinder
valve is turned o. Grasp the coupler and turn counter-
clockwise. The inlet will then disengage.
Liquid Propane regulator
for a portable tank
Connects to
portable tank
Connects to
manifold